Quartz Erlenmeyer Flask: Preparing a Sample Before Measurement

Choose the vessel around the operation. The nominal capacity identifies the option, while the intended working level, neck access and transfer method describe how it will be used.

In this guide: Configuration · Design comparison · Leave the mixing operation room to happen · The neck must suit the transfer tool · From an open preparation flask to a custom request · Do not confuse mixing volume with calibrated volume · Enquiry

The configuration discussed here

What changes from the simpler form?

Compared with a straight-sided sample cell, the conical flask separates a broad preparation body from a narrower loading neck. That is a container-layout choice; it does not make the flask an optical-path or calibrated-volume device.

Leave the mixing operation room to happen

If your procedure involves moving the flask to mix its contents, describe the intended fill and the way the vessel is supported. The volume printed in an option name is not a recommendation to fill the vessel to that level for every operation.

A low holder or enclosure may restrict movement around the conical body. Show the outside envelope you can accept, the surface that supports it and the clearance above the neck. Those dimensions cannot be taken from a photograph shared by several flask sizes.

The neck must suit the transfer tool

A narrower neck can change the approach for a pipette, funnel or other filling tool. Specify the actual tool diameter and reach if they matter to the method. Also describe how the prepared sample leaves the flask: pouring and withdrawal through the mouth ask different things of the opening.

If a stopper is required, request the appropriate closed configuration rather than assuming one is included with MQQFS002. The stopper and neck pairing should be stated as part of the supplied set.

From an open preparation flask to a custom request

A possible change is to retain the conical vessel form while adjusting the neck envelope to clear an existing tool. Mark the body dimensions to keep and the neck dimensions to review. Include the working fill and the available space around the flask.

A side connection, different joint or closed operating arrangement is a further design question, not an automatic option. MQ can discuss the proposed geometry and relevant operating conditions before the drawing and quotation are agreed.

Do not confuse mixing volume with calibrated volume

This flask is presented as a preparation vessel. The nominal 100 mL option does not establish a calibrated contained volume, sterile supply or any particular heating qualification. If a method depends on those attributes, include the required evidence in the enquiry.

For dimensional fit, identify the neck, widest body section and support footprint that matter to your setup. Agree a trial fit or dimensional record for those features rather than relying on a visually similar flask.

Structure reference and specification points

Download the structure reference (PDF)

Is a stopper included with the 100 mL open flask?

The selected option is without a stopper. If a closed arrangement is needed, specify the stopper and mating neck together and confirm the supplied components for that option.